Chapter 72 Telnet Client Command List - D-Link DGS-1510/ME Series Reference Manual

Chapter 72 Telnet Client Command List

telnet <ipaddr> {tcp_port <value 1-65535>}
72-1 telnet
Description
This command is used to start the telnet client to connect to the specific telnet server. The parameters specified by
the command will only be used for the establishment of this specific session. They will not affect the establishment
of other sessions.
Format
telnet <ipaddr> {tcp_port <value 1-65535>}
Parameters
<ipaddr> - Enter the IP address of the telnet server.
tcp_port - (Optional) Specifies the Telnet server port number to be connected. If not specified, the default port is
23.
<value 1-65535> - Enter the TCP port number used here. This value must be between 1 and 65535.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
Telnet to a Switch by specifying the IP address:
DGS-1510-28XMP/ME:admin# telnet 10.90.90.90
Command: telnet 10.90.90.90
Copyright(C) 2014 D-Link Corporation. All rights reserved.
UserName:
DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
DES-3200-28P Fast Ethernet Switch
Command Line Interface
Firmware: Build 4.05.003
591