D-Link DGS-1510/ME Series Reference Manual page 436

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
DGS-1510-28XMP/ME:admin# config stp priority 61440 instance_id 0
Command: config stp priority 61440 instance_id 0
Success.
DGS-1510-28XMP/ME:admin#
49-14 config stp version
Description
This command is used to enable STP globally.
Format
config stp version [mstp | rstp | stp]
Parameters
mstp - Specifies to run under Multiple Spanning Tree Protocol.
rstp - Specifies to run under Rapid Spanning Tree Protocol.
stp - Specifies to run under Spanning Tree Protocol.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure STP version:
DGS-1510-28XMP/ME:admin# config stp version mstp
Command: config stp version mstp
Success.
DGS-1510-28XMP/ME:admin#
To config STP version with the same value of old configuration:
DGS-1510-28XMP/ME:admin# config stp version mstp
Command: config stp version mstp
Configure value is the same with current value.
Success.
DGS-1510-28XMP/ME:admin#
432