Chapter 74 Time And Sntp Command List - D-Link DGS-1510/ME Series Reference Manual

Chapter 74 Time and SNTP Command List

config sntp {primary <ipaddr> | secondary <ipaddr> | poll-interval <int 30-99999>}
show sntp
enable sntp
disable sntp
config time <date ddmthyyyy> <time hh:mm:ss>
config time_zone {operator [+ | -] | hour <gmt_hour 0-13> | min <minute 0-59>}
config dst [disable | repeating {s_week <start_week 1-4,last> | s_day <start_weekday sun-sat> | s_mth
<start_mth 1-12> | s_time <start_time hh:mm> | e_week <end_week 1-4,last> | e_day <end_weekday sun-
sat> | e_mth <end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60 | 90 | 120]} | annual {s_date
<start_date 1-31> | s_mth <start_mth 1-12> | s_time <start_time hh:mm> | e_date <end_date 1-31> | e_mth
<end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60 | 90 | 120]}]
show time
74-1 config sntp
Description
This command is used to change SNTP configurations.
Format
config sntp {primary <ipaddr> | secondary <ipaddr> | poll-interval <int 30-99999>}
Parameters
primary - (Optional) Specifies the SNTP primary server IP address.
<ipaddr> - Enter the IP address used for this configuration here.
secondary - (Optional) Specifies the SNTP secondary server IP address.
<ipaddr> - Enter the IP address used for this configuration here.
poll-interval - (Optional) Specifies the polling interval range seconds.
<int 30-99999> - Enter the polling interval range here. This value must be between 30 and 99999 seconds.
Restrictions
Only Administrators and Operators can issue this command.
Example
To configure SNTP:
DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
601