D-Link DGS-1510/ME Series Reference Manual page 565

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
DGS-1510-28XMP/ME:admin# config snmp warmstart_traps enable
Command: config snmp warmstart_traps enable
Success.
DGS-1510-28XMP/ME:admin#
67-32 show snmp traps
Description
This command is used to display the SNMP trap sending status.
Format
show snmp traps {linkchange_traps {ports <portlist>}}
Parameters
linkchange_traps - (Optional) Specifies that the SNMP trap sending status will be displayed.
ports - (Optional) Specifies the ports to be displayed.
<portlist> - Enter the list of ports used here.
Restrictions
None.
Example
To display SNMP trap sending status:
DGS-1510-28XMP/ME:admin# show snmp traps
Command: show snmp traps
SNMP Traps
Authenticate Trap
Linkchange Traps
Coldstart Traps
Warmstart Traps
DGS-1510-28XMP/ME:admin#
67-33 config rmon trap
Description
This command is used to configure the trap state for RMON events.
Format
config rmon trap {rising_alarm [enable | disable] | falling_alarm [enable | disable]}(1)
: Enabled
: Enabled
: Enabled
: Enabled
: Enabled
561