Chapter 55 Port Security Command List - D-Link DGS-1510/ME Series Reference Manual

Chapter 55 Port Security Command List

config port_security system max_learning_addr [<max_lock_no 1-3328> | no_limit]
config port_security ports [<portlist> | all] [{admin_state [enable | disable] | max_learning_addr <max_lock_no
0-3328> | lock_address_mode [permanent | deleteontimeout | deleteonreset]} (1)| {vlan [<vlan_name 32> |
vlanid <vidlist>] max_learning_addr [<max_lock_no 0-3328> | no_limit]}(1)]
config port_security vlan [<vlan_name 32> | vlanid <vidlist>] max_learning_addr [<max_lock_no 0-3328> |
no_limit]
delete port_security_entry [vlan <vlan_name 32> | vlanid <vlanid 1-4094>] mac_address <macaddr>
clear port_security_entry {ports [<portlist> | all] {[vlan <vlan_name 32> | vlanid <vidlist>]}}
show port_security_entry {ports {<portlist>} {[vlan <vlan_name 32> | vlanid <vidlist>]}}
show port_security {ports {<portlist>} {[vlan <vlan_name 32> | vlanid <vidlist>]}}
enable port_security trap_log
disable port_security trap_log
55-1 config port_security system max_learning_addr
Description
This command is used to set the maximum number of port security entries that can be authorized system wide.
There are four levels of limitations on the learned entry number; for the entire system, for a port, for a VLAN, and
for a specific VLAN on a port. If any limitation is exceeded, the new entry will be discarded.
The setting for system level maximum learned users must be greater than the total of maximum learned users
allowed on all ports.
Format
config port_security system max_learning_addr [<max_lock_no 1-3328> | no_limit]
Parameters
<max_lock_no 1-3328> - Specifies the maximum number of port security entries that can be learned by the
system. If the setting is smaller than the number of current learned entries on all enabled ports, the command
will be rejected. This value must be between 1 and 3328.
no_limit - Specifies that there is no limitation on the number of port security entries that can be learned by the
system. This is the default option.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the maximum number of port security entries on the Switch to be 256:
DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
457