Ford 2003 Mustang Workshop Manual page 1103

Install the valve tappets.
Install the tappet guide plates and retainers.
Install the bolts.
34. NOTE: Lubricate the push rods with clean engine oil prior to installation.
Install the 12 push rods.
35. Install the 12 rocker arms. For additional information, refer to
36. NOTE: Use pipe sealant with Teflon® on studs No. 4 and 6, and bolt No. 12.
Using a new gasket, install the engine front cover. Tighten the nuts and the bolts in the
sequence shown.
Install a 135.5 mm (5.42 in) stud at location No. 5 and tighten to 7 Nm (62 lb-in).
Install a 137 mm (5.48 in) stud at locations No. 4, 6, 7 and 10, and tighten to 7 Nm (62 lb-
in).
Using a new gasket, install the water pump.
Tighten bolt No. 12 to 10 Nm (89 lb-in). All other nuts and bolts are to be tightened to 28
Rocker Arm in this section.