Ford 2003 Mustang Workshop Manual page 1093

Adapter, Crankshaft Rear Seal
(Use only the adapter and the
center jack screw)
303-S560 (T96T-6701-A)
Spreader Bar
303-D089 (D93P-6001-A3)
Material
Item
Metal Surface Cleaner
F4AZ-19A536-RA or equivalent
Silicone Gasket and Sealant
F7AZ-19554-EA or equivalent
SAE 5W-20 Premium Synthetic
Blend Motor Oil
XO-5W20-QSP or equivalent
Pipe Sealant with Teflon®
XW7Z-19554-AA
CAUTION: The moving components must be lubricated with clean engine oil before
assembly.
CAUTION: The components with oil holes must be correctly aligned with the oil feed
holes.
1. If necessary, install the following:
1. the cylinder block dowels.
2. the oil gallery plugs.
3. the water jacket plugs.
2. If equipped, install the engine coolant heater. For additional information refer to
03A .
3. Using the camshaft bearing service set, install the engine dynamic balance shaft bearings.
Specification
WSE-M5B392-
A
WSE-M4G323-
A4
WSS-M2C153-
H
WSK-M2G350-
A2
Section 303-