8.2.2
Replacing the HDD fan module for 2.5-inch version
Figure 72: Position of the additional air duct
8.2.2.1
Required tools
Preliminary and concluding steps: tool-less
●
Replacing the fan module: tool-less
●
8.2.2.2
Preliminary steps
Before replacing the HDD fan module, perform the following steps:
Ê Locate the defective server as described in section
server" on page
Ê Shut down the defective server as described in section
server" on page
Ê Disconnect the AC power cord from the system.
Ê Remove the server cover as described in section
page
55.
Ê Open the front cage as described in section
page
60.
TX1320 M1
44.
52.
Upgrade and Maintenance Manual
System fan and HDD fan
"Locating the defective
"Shutting down the
"Opening the server" on
"Opening the front cage" on
165