Setting Commands - Fujitsu PRIMEQUEST 2000 Series Tool Reference

MMB CLI (Command Line Interface) Operations

2.2 Setting Commands

2.2 Setting Commands
The information setting commands are as follows:
2.2.1 add partition
2.2.2 clear access_control
2.2.3 clear ssh_key
2.2.4 console
2.2.5 download ssh_key
2.2.6 power off
2.2.7 power on
2.2.8 sadump
2.2.9 reset
2.2.10 nmi
2.2.11 remove partition
2.2.12 set active_mmb
2.2.13 set date
2.2.14 set partition dynamic_reconfiguration
2.2.15 set gateway
2.2.16 set gateway_ipv6
2.2.17 set hostname
2.2.18 set http
2.2.19 set http_port
2.2.20 set https
2.2.21 set https_port
2.2.22 set ip
2.2.23 set ipv6
2.2.24 set maintenance_ip
2.2.25 set partition home
2.2.26 set partition lan_device_mode
2.2.27 set partition memory_mirror_ras_mode
2.2.28 set partition memory_operation_mode
2.2.29 set partition name
2.2.30 set partition pci_address_mode
2.2.31 set partition pci_express_mode
2.2.32 set ssh
2.2.33 set ssh_port
2.2.34 set telnet
2.2.35 set telnet_port
2.2.36 set timezone
2.2.37 set partition extended_partitioning_mode
2.2.38 set partition dimm_excl_mode
2.2.39 set partition skt_binding_mode
2.2.40 add extended_partition sb
2.2.41 add extended_partition iou
2.2.42 add extended_partition pcibox
2.2.43 remove extended_partition sb
2.2.44 remove extended_partition iou
2.2.45 remove extended_partition pcibox
2.2.46 hotadd partition
2.2.47 hotremove partition
2.2.48 pciinfo partition
2.2.49 set partition extended_socket_mode
2.2.50 set partition extended_socket_zone
2.2.51 set partition memory_sparing_mode
2.2.52 create raid logical_drive
2.2.53 delete raid logical_drive
2.2.54 modify raid logical_drive_policy
2.2.55 modify raid logical_drive
2.2.56 create raid global_hotspare
2.2.57 create raid dedicated_hotspare
2.2.58 delete raid hotspare
2.2.59 start raid locate_pd
2.2.60 stop raid locate_pd
CA92344-0539-04
358