Show Raid Logical_Drive - Fujitsu PRIMEQUEST 2000 Series Tool Reference

MMB CLI (Command Line Interface) Operations
2.6 PRIMEQUEST 2800B2/2800B model Commands

2.6.47 show raid logical_drive

Displays logical drive information attached to the specified RAID adapter.

Privilege: Aｌｌ
(1) Input format
show raid logical_drive [SB | DU | IOU | PCI_BOX] <UNIT#>-<PCISLOT#>
{target=<Target#>} {action-progress}
(2) Option
target: This option specifies target id (ex. target=0)
action-progress: This option shows action progress for the specify logical drive.
(3) Usage example

Example: When you display logical drive list attached to the RAID adapter on SB#0.
# show raid logical_drive SB 0-0
Target Id
0
1

Example: When you display the logical drive#1 on SB#0.
# show raid logical_drive SB 0-0 target=1
Target ID:
Status:
Name:
RAID level:
Strip size
Logical size
Read mode
Write mode:
Cache mode:
Disk cache mode:
Background initialization:
Action in progress
Configured drives:
Slot
1
2
(4) Message
The following table lists the messages which are displayed in this CLI.
For details of the messages, see the PRIMEQUEST 2000 Series Message Reference (CA92344-0540)..
No logical drive is assigned to the controller.
Too much arguments argc=%d.
Too few arguments argc=%d.
The specified parameter is invalid. %s
The specified controller is not found.
Status Name
Operational RHEL7
Operational WS2012R2
1
Operational
WS2012R2
RAID-1
64K
278.00 GB
Read-ahead
Write-back
Direct
Disabled
Enabled
Back ground initialization
Span Start block
0 0
0 0
Size
136.00 GB
278.00 GB
Length[Blocks] Length[MB/GB]
584843264 285568/278
584843264 285568/278
544
RAID Action in progress
RAID-0 -
RAID-1 Back ground initialization
CA92344-0539-04