Set Partition Dynamic_Reconfiguration - Fujitsu PRIMEQUEST 2000 Series Tool Reference

MMB CLI (Command Line Interface) Operations
2.2 Setting Commands
(3) Usage example
None
(4) Message
The following table lists the messages which are displayed in this CLI.
For details of the messages, see the PRIMEQUEST 2000 Series Message Reference (CA92344-0540).
The specified date is invalid.
Unable to set date because NTP is enabled.
Time synchronization was requested to Standby MMB.
Unable to execute this command on a standby MMB.

2.2.14 set partition dynamic_reconfiguration

Sets the enable/disable of Dynamic Reconfiguration of the specified partition.
When executing the settings by this command for the partition whose power is already on, message shown
below is displayed, and settings cannot be done.
"Unable to change the mode while the partition is running.
Please try to change the mode after the partition is shutdown."
When settings of the partition for which power supply is already switched off are to be changed, it is not
necessary to turn On / Off the power supply. The value set at that instant is reflected without displaying the
above-mentioned message.
When Memory Scale-up Board is built into specified Partition, the specified partition cannot be operated

Privilege: Administrator
(1) Input format
set partition dynamic_reconfiguration <partition#>[disable|enable]{quiet}
(2) Option
quiet: The command is executed without interactive operation to User.
(3) Usage example

Example : When Dynamic Reconfiguration of partition #3 is enabled
# set partition dynamic_reconfiguration 3 enable
(4) Message
The following table lists the messages which are displayed in this CLI.
For details of the messages, see the PRIMEQUEST 2000 Series Message Reference (CA92344-0540).
The specified partition number is invalid.
The specified parameter is invalid.
Unable to execute this command on a standby MMB
Failed to execute set partition dynamic_reconfiguration command.
Unable to change the mode while the partition is running.
Please try to change the mode after the partition is shutdown.
DR can't be enabled, because of no DR license.
Unable to execute this command because [Extended Partitioning mode| PCI Bus mode| TPM | Fixed mode] of
the Partition#%d is Enabled
372
CA92344-0539-04