Set Partition Name - Fujitsu PRIMEQUEST 2000 Series Tool Reference

MMB CLI (Command Line Interface) Operations
2.2 Setting Commands

2.2.29 set partition name

I It sets the name of the specified partition.
The name of the partition is up to 16 characters. The name that contains the characters exceeding the 16
characters cannot be set.
If the name contains space, it is enclosed within "".
The characters that can be used are as follows.
[a-z], [A-Z], [0-9], "-", (Under bar), "_" (hyphen), "#" (Sharp), "" (Blank)
No default value is set.

Privilege: Administrator
(1) Input format
set partition name <partition#> <partition name>
(2) Option
None
(3) Usage example
Example: When setting the name "hogehoge" to the Partition3
# set partition name 3 hogehoge
#
(4) Message
The following table lists the messages which are displayed in this CLI.
For details of the messages, see the PRIMEQUEST 2000 Series Message Reference (CA92344-0540).
The specified partition number is invalid.
The specified partition name is invalid.
Partition#x is not defined.
Unable to execute this command on a standby MMB.
The specified parameter is invalid.
Unable to execute this command because the system is under maintenance.
Unable to execute this command because the Partition#x is under maintenance.
Succeed to set partition name command.
Failed to execute set partition name command.
Failed to execute %s command.
The specified command is not supported.(error=[%s])
385
CA92344-0539-04