Start Raid Locate_Pd - Fujitsu PRIMEQUEST 2000 Series Tool Reference

MMB CLI (Command Line Interface) Operations
2.2 Setting Commands

2.2.59 start raid locate_pd

Turns on a location LED of the specified disk.

Privilege: Administrator, Operator, Partition Operator (Only managed partition)
(1) Input format
start raid locate_pd [SB | DU | IOU | PCI_BOX] <UNIT#>-<PCISLOT#>
disk=[<DISKSLOT#> | <PORT#>-<CASCADE#>-<DISKSLOT#>]
(2) Option
disk: This option specifies disk slot numbers for the internal disks (e.g. disk=0) or port number and cascade
numbers and disk slot numbers for the external disks on disk enclosures (e.g. disk=0-0-0).
(3) Usage example

Example:When you turn on a location LED of a disk attached to slot#0.
# start raid locate_pd SB 0-0 disk=0
(4) Message
The following table lists the messages which are displayed in this CLI.
For details of the messages, see the PRIMEQUEST 2000 Series Message Reference (CA92344-0540).
The command is executed successfully.
Too much arguments argc=%d.
Too few arguments argc=%d.
The specified parameter is invalid. %s
The specified controller is not found.
Port and cascade number is required in the parameter since more than 2 enclosures are connected.
Internal error [%d:%d].
The operation is failed. %s
Unable to execute the command because the %s is under maintenance.
Unable to process raid operation because you have not authority to access to the system assigned to the raid
controller.
Unable to process raid operation because you have not authority to access to the Partition#%d assigned to the
raid controller.
418
CA92344-0539-04