Table 3.35 Display Contents Of Menu Selection; Table 3.36 Display Contents Of Operation Help Display - Fujitsu PRIMEQUEST 2000 Series Tool Reference

UEFI Menu Operations
3.4 [Device Manager] Menu

TABLE 3.35 Display Contents of Menu Selection

Item
DIMM Speed (*1)
Patrol Scrub (*1)
Refresh Rate (*1)
Memory Power States (*1)
[Only for PRIMEQUEST
2400E2/2800E2/2800B2]
DDR4 Command/Address
Parity Check and Retry (*1)
Commit Changes and Exit
Discard Changes and Exit
*1: As settings of Physical Partition remain same in Extended Partitioning, settings are only displayed but
cannot be changed.
(3) Operation help display
Description of help key is shown in the

TABLE 3.36 Display Contents of Operation Help Display

Item
↑↓= Move Highlight
<Enter>=Select Entry
Esc=Exit
Sets the operating speed of memory module.
[For PRIMEQUEST 2400E/2800E/2800B]
 Performance Mode: Sets maximum possible operating frequency for
this mode.
Normal Mode: Sets the maximum possible operating frequency that can
be operated by 1.35V voltage for this mode.
Default setting is Normal mode.
[For PRIMEQUEST 2400E2/2800E2/2800B2]
It is not displayed for DDR4 because it operates only by 1.2V.
Scans memory module at regular interval. If CE is detected, the function
which writes back the corrected data is enabled / disabled.
・Disabled
・Enabled
Default setting is Disabled
Sets the refresh rate of the memory.
・Auto
・1x
Default setting is Auto
Sets the Power State of the memory.
・Default
・Perfomance Mode
Default setting is Default
Sets the DDR4 Command/Address Parity Check and Retry function to
enable or disable.
・Enabled
・ Disabled
Default setting is Enabled.
Saves the changed contents and exits from this menu.
Cancels the changed contents and exits from this menu.
"TABLE 3.36 Display Contents of Operation Help
Moves cursor up and down.
Selects item.
Returns to "3.1 Front page of Boot
menu'.
599
Description
Description
without saving changes of this
Manager"
Display".
CA92344-0539-04