Fujitsu PRIMEQUEST 2000 Series Tool Reference page 404

MMB CLI (Command Line Interface) Operations
2.2 Setting Commands
(4) Message
The following table lists the messages which are displayed in this CLI.
For details of the messages, see the PRIMEQUEST 2000 Series Message Reference (CA92344-0540).
Are you sure to continue adding [SB#%d|IOU#%d] to partition#%d? [Y/N]:
DR operation start (1/5)
Assigning SB#%d to partition#%d (2/5)
Testing SB#%d (3/5)
Reconfiguring partition#%d (4/5)
Onlining added Memory/CPU (5/5)
DR operation start (1/3)
Assigning IOU#%d to partition#%d (2/3)
Power on IOU#%d(3/3)
Adding [SB#%d|IOU#%d] to partition#%d has been completed successfully.
The specified [SB#%d|IOU#%d] is not present.
The specified [SB#%d|IOU#%d] is power-on.
The specified Partition#%d is no Home.
Hot-add [SB#%d|IOU#%d] failure.
Unable to hot-add SB due to firmware mismatch.
Unable to hot-add SB due to SB revision mismatch.
Unable to hot-add SB due to CPU mismatch.
Unable to hot-add SB due to DIMM mismatch.
Unable to power on the DR test partition.
Unable to power off the DR test partition.
Check DR Unit Error
Unable to onlining the DR target bmc.
Unknown Error Code =0xXX
The specified SB#%d is not supported.
Failed to execute hotadd partition command.
Unable to execute this command on a standby MMB.
Hot-add [SB#%d|IOU#%d] failed.
Failed to execute DR operation. Fatal error occurred.
Unable to power on the IOU.
Unable to power on the PCIBox.
Failed to create DR test partition.
Failed to execute DR operation. Partition is stopped.
DR sequence timeout: added SB power on failure
DR sequence timeout: SB hot-add OS failure
DR sequence timeout: SB hot-add request failure
DR sequence timeout: QPI connection failure
BIOS Error Code =0xXX
The specified [SB#%d|IOU#%d] is not free or reserved.
DR can't be enabled, because of no DR license
DR feature is disabled.
Unable to execute DR command while other DR command is running
Unable to execute DR command due to previous failure.
Unable to hot-add SB while firmware updating.
Unable to execute DR command because OS is not ready for DR operation
403
CA92344-0539-04