Appendix A List of Setting Items
A.2
Setting Item
Reverse CHAP
Name
Reverse CHAP
Secret
A.2.5
Setting Items on [Memory Configuration] Window
Following table lists the initial value and the values that can be set for Setting Items on [Memory
Configuration] window.
Setting Item
DIMM Speed(*1)
Patrol scrub(*1)
Refresh Rate(*1)
Memory Power
States (*1)
DDR4
Command/Address
Parity Check and
Retry (*1)
*1: As settings of Physical Partition remain same in Extended Partitioning, settings are only displayed but
cannot be changed.
A.2.6
Setting Items on [USB Configuration] Window
Following table lists the initial value and the values that can be set for Setting Items on [USB Configuration]
window.
Setting Item
Legacy USB
Support
Setting Items on UEFI
Initial Value
-
-
TABLE A.42 Setting Items of [Memory Configuration] Window
Initial Value
Normal Mode
Disabled
Auto
Default
Enabled
TABLE A.43 Setting Items of [USB Configuration] Window
Initial Value
Enabled
Setting Value
125 characters can be
entered. The types of
characters that can be entered
are as follows.
0-9, A-Z, a-z,! " # $ % & ' ( ) *
+ ,‐ . / : ; < = > ? @ [ ¥ ] ^ _ `
{ | }.~
12~16 characters can be
entered. The types of
characters that can be entered
are as follows.
0-9, A-Z, a-z,! " # $ % & ' ( ) *
+ ,‐ . / : ; < = > ? @ [ ¥ ] ^ _ `
{ | }.~
Setting Value
Performance Mode
Normal Mode
Disabled
Enabled
Auto
1x
・Default
・Perfomance Mode
・Disabled
・Enabled
Setting value
Disabled
Enabled
Auto
729
Remarks
Remarks
This item is not displayed
for PRIMEQUEST
2400E2/2800E2/2800B2.
Only for PRIMEQUEST
2400E2/2800E2/2800B2
Remarks
CA92344-0539-04