Stop Raid Locate_Encl - Fujitsu PRIMEQUEST 2000 Series Tool Reference

MMB CLI (Command Line Interface) Operations
2.2 Setting Commands

2.2.64 stop raid locate_encl

Turns off a location LED of the specified disk enclosure.

Privilege: Administrator, Operator, Partition Operator (Only managed partition)
(1) Input format
stop raid locate_encl [SB | DU | IOU | PCI_BOX] <UNIT#>-<PCISLOT#> encl=<PORT#>-
<CASCADE#>
(2) Option
encl: This option specifies port number of the RAID card where the disk enclosure connected. And specify
cascade number of the disk enclosure. (ex. encl=0-0).
(3) Usage example

Example:When you turn off a location LED of a disk attached to slot#0.
# stop raid locate_pd SB 0-0 disk=0
(4) Message
The following table lists the messages which are displayed in this CLI.
For details of the messages, see the PRIMEQUEST 2000 Series Message Reference (CA92344-0540).
The command is executed successfully.
Too much arguments argc=%d.
Too few arguments argc=%d.
The specified parameter is invalid. %s
The specified controller is not found.
Port and cascade number is required in the parameter since more than 2 enclosures are connected.
Internal error [%d:%d].
The operation is failed. %s
Unable to execute the command because the %s is under maintenance.
Unable to process raid operation because you have not authority to access to the system assigned to the raid
controller.
Unable to process raid operation because you have not authority to access to the Partition#%d assigned to the
raid controller.
423
CA92344-0539-04