Setting Up The Floorstand Model - Fujitsu T2555SC020IN Operating Manual

5.3

Setting up the floorstand model

I
If you are not installing a PRIMERGY TX2550 M5 floorstand model, skip
this section and continue reading at section
rack" on page
V
CAUTION!
Note the safety instructions in chapter
page 43.
Ê Transport the server to the place where you want to set it up.
Ê Unpack the server (see section
Ê Set up the server.
V
CAUTION!
– The device must be protected from direct sunlight.
– The required minimum distances for operation and maintenance
areas must be adhered to.
– The server must be accessible at the rear for connection to other
devices (e.g. memory subsystem).
– The mains plug must be accessible easily and safely.
– There must be a clearance of at least 200 mm in front of and
behind the server to ensure adequate ventilation of the
subsystem.
Ê Connect the devices to the server, see section
server" on page 68
on page 67.
Ê Connect the server to the mains, see
page 69.
TX2550 M5
62.
"Unpacking the server" on page
and section "Notes on connecting/disconnecting cables"
Operating Manual
"Installing the server in the
"Important information" on
"Connecting devices to the
section"Connecting the power cord" on
Starting up
60).
61