Fujitsu PRIMEQUEST 2000 Series Tool Reference page 208

MMB Web-UI (Web User Interface) Operations
1.3 [Partition] Menu for PRIMEQUEST 2400E2/2800E2/2400E/2800E
[Message]
This section describes the messages to be displayed on this window.
Message Number
E_00089 Mode setting failed.
E_00090 Power Control [Reset] setting failed.
E_00461 Unable to register the specified Partition#%s as Mode enable because the DIMM
does not satisfy requirements of Mode.
W_00487 Unable to change the mode, because this partition is powered on.
E_00497 Unable to register the specified Partition#%s as Mode enable because the CPU
mismatch between SBs.
E_00498 Unable to register the specified Partition#%s as Mode enable because the
unsupported CPU configuration.
E_00499 Unable to register the specified Partition#%s as Mode enable because of abnormal
CPU composition.
E_00500 Unable to register the specified Partition#%s as Mode enable because of abnormal
DIMM composition.
I_00501 The SB with DIMM that does not satisfy requirements of Mode is registered as a
Reserved SB.
If you register this partition as a Mode, Mode will be disabled when switching to
Reserved SB. Are you sure to continue?
E_00521 Unable to register the specified Partition#%s as Mode enable because of abnormal
SB composition.
W_00584 The Dynamic Reconfiguration Mode cannot be changed while the Partition is
Extended Partitioning Mode.
W_00585 Dynamic Reconfiguration Mode cannot be set to this Partition because of PCI Bus.
Mode
W_00586
Dynamic Reconfiguration Mode cannot be set to this Partition because of Fixed I/O
Mode.
E_00594 Dynamic Reconfiguration Mode cannot be changed due to the partition has Memory
Scale-up Board.
W_00602
Unable to set Extended Partitioning Mode because Partition Power Save Control is
enabled.
For details on the messages displayed on the window, see
(CA92344-0540).
Message
PRIMEQUEST 2000 Series Message Reference
207
CA92344-0539-04