Start Raid Locate_Ld - Fujitsu PRIMEQUEST 2000 Series Tool Reference

MMB CLI (Command Line Interface) Operations
2.2 Setting Commands

2.2.61 start raid locate_ld

Turns on a location LED of disks assigned to the specified logical drive.

Privilege: Administrator, Operator, Partition Operator (Only managed partition)
(1) Input format
start raid locate_ld [SB | DU | IOU | PCI_BOX] <UNIT#>-<PCISLOT#>
target=<TargetID>
(2) Option
target: This option specifies targetID of the logical drive where you want to operate LEDs of physical drives
assigned. (ex. target=0).
(3) Usage example

Example:When you turn on a location LED of a disk assigned to the logical drive#1.
# start raid locate_ld SB 0-0 target=1
(4) Message
The following table lists the messages which are displayed in this CLI.
For details of the messages, see the PRIMEQUEST 2000 Series Message Reference (CA92344-0540).
The command is executed successfully.
Too much arguments argc=%d.
Too few arguments argc=%d.
The specified parameter is invalid. %s
The specified controller is not found.
Internal error [%d:%d].
The operation is failed. %s
Unable to execute the command because the %s is under maintenance.
Unable to process raid operation because you have not authority to access to the system assigned to the raid
controller.
Unable to process raid operation because you have not authority to access to the Partition#%d assigned to the
raid controller.
420
CA92344-0539-04