Table 1.128 Setting And Display Items In The [Add Filter] Window; Table 1.129 Buttons In The [Add Filter] Window - Fujitsu PRIMEQUEST 2000 Series Tool Reference

MMB Web-UI (Web User Interface) Operations
1.5 [Network Configuration] Menu

TABLE 1.128 Setting and display items in the [Add Filter] window

Items
Protocol
Sets the protocol for the IP filtering. You can select one of the following items from the
pull-down menu:

HTTP

HTTPS

Telnet

SSH

SNMP
Access Control
Sets whether to execute access control.

Disable: Permits access by all IP addresses via the protocol selected in [Protocol].
Selecting this disables input to [IP Address] and [Subnet Mask].

Enable: Specifies [IP Address] and [Subnet Mask] to permit access via the protocol
selected in [Protocol].
IP Address
Sets the IP address (for IPv4 or IPv6) that will have permission to connect.
Remarks
For IPv4, to permit connection by only a specific IP address in a subnet, specify the IP
address and then "255.255.255.255" in [Subnet Mask]. For IPv6, the prefix length is
displayed.
Example: Permitting access from a specific IP address range (e.g.,
192.168.60.60/255.255.255.0)
IP Address: 192.168.60.60
Subnet Mask: 255.255.255.0
(because the IP address is used with a 24-bit subnet mask)

The above setting will enable access not only from the IP address 192.168.60.60, but
also from IP addresses within the subnet 192.168.60.0/24.
Subnet Mask/
For IPv4, the subnet mask of the IP address that has permission to connect is displayed.
Prefix Length
For IPv6, the prefix length is displayed.

TABLE 1.129 Buttons in the [Add Filter] window

Buttons
Apply Sets the specified information.
Cancel Restores the original information and does not set the specified information, such as protocols
and access control.
(1) Menu Operation
[Network Configuration] - [Access Control] - [Add Filter] button/[Edit Filter] button
(2) Window Operations
1. Specify [Protocol] and [Access Control].
2. If you specify [Enable] in [Access Control], enter values for [IP Address] and [Subnet Mask]. Then, click
the [Apply] button.
If you specify [Disable] in [Access Control], simply click the [Apply] button.
This adds or edits the filter.
[Message]
The following table lists the messages displayed in this window.
Message Number
I_00013 Setting completed.
W_00432 Invalid IP Address specified.
For details on the messages displayed on the window, see
(CA92344-0540).
Description
Description
Message
PRIMEQUEST 2000 Series Message Reference
267
CA92344-0539-04