CHAPTER 1
RAPID CONFIGURATION
STEP 1 - CONNECT THE SYSTEM
To connect the system in a Stand Alone configuration, you need the hardware
indicated in Figure 1. In this layout the data is transmitted to the Host on the main
serial interface. Data can also be transmitted on the RS232 auxiliary interface irrespec-
tive of the main interface selection.
When One Shot or Phase Mode Operating mode is used, the reader is activated by an
External Trigger (photoelectric sensor) when the object enters its reading zone.
PG6000
CAB-DSxx-S
Matrix 300N
I/O, Aux
Figure 4 - Matrix 300N in Stand Alone Layout
CBX
Main Serial Interface
(RS232 or RS422 Full-Duplex)
External Trigger
(for One Shot or Phase Mode)
PRODUCT REFERENCE GUIDE
Host
1