Table of Contents
Advertisement
8 Access and configuration
74
dows installation. However, you can also use any other terminal program that can be set to
the corresponding parameters (see below).
Proceed as follows to access your device via the serial interface:
(1) In the Windows Start menu, click Programs -> Accessories -> Communication ->
HyperTerminal -> Device on COM1 (or Device on COM2, if you use the COM2 port
of your PC) to start HyperTerminal.
(2) Press Return (at least once) after the HyperTerminal window opens.
A window with the login prompt appears. You are now in the SNMP shell of your device.
You can now log in on your device and start the configuration.
Check
If the login prompt does not appear after you press Return several times, the connection to
your device has not been set up successfully.
Therefore, check the COM1 or COM2 settings on your PC.
(1) Click on File ->Properties.
(2) Click Configure in the Connect to tab.
The following settings are necessary:
- Bits per second:
- Data bits:
- Parity:
- Stopbits:
- Flow control:
(3) Enter the values and click OK.
(4) Make the following settings in the Settings tab:
- Emulation:
(5) Click OK.
The changes to the terminal program settings do not take effect until you disconnect the
connection to your device and then make the connection again.
If you use HyperTerminal, there may be problems with displaying umlauts and other special
characters. If necessary, therefore, set HyperTerminal to
.
Unix
You will require a terminal program such as
(on Linux). The settings for these programs correspond to those listed above.
Funkwerk Enterprise Communications GmbH
(on System V),
(on BSD) or
instead of
R1xxx/R3xxx/R4xxx
Advertisement
Table of Contents
