Table of Contents
Advertisement
Funkwerk Enterprise Communications GmbH
R1xxx/R3xxx/R4xxx
Field
MAC Address
VLAN ID
The menu Advanced Settings consists of the following fields:
Fields in the Advanced Settings menu
Field
DHCP MAC Address
DHCP Hostname
DHCP Broadcast Flag
Description
Address is optional in this module.
Only with virtual interfaces and only for Interface Mode =
Enter the MAC address associated with the interface. For virtual
interfaces, you can use the MAC address of the physical inter-
face under which the virtual interface was created, but this is not
necessary. You can also allocate a virtual MAC address. The
first 6 characters of the MAC are preset (but can be changed).
Only for Interface Mode =
This option only applies for routing interfaces. Assign the inter-
face to a VLAN by entering the VLAN ID of the relevant VLAN.
Possible values are
(default value) to
Description
Only for Address Mode =
If Use built-in is activated (default setting), the hardware MAC
address of the Ethernet interface is used. In the case of physical
interfaces, the current MAC address is entered by default.
If you disable Use built-in, you enter an MAC address for the
virtual interface, e.g.
Some providers use hardware-independent MAC addresses to
allocate their clients IP addresses dynamically. If your provider
has assigned you a MAC address, enter this here.
Only for Address Mode =
Enter the host name requested by the provider. The maximum
length of the entry is 45 characters.
Only for Address Mode =
Choose whether or not the BROADCAST bit is set in the DHCP
requests for your device. Some DHCP servers that assign IP
.
.
.
.
.
12 LAN
151
Advertisement
Table of Contents
