Table of Contents
Advertisement
18 VPN
308
Fields in the Advanced Settings menu
Field
Local IP Address
Hello Intervall
Minimum Time
between Retries
Maximum Time
between Retries
Maximum Retries
Data Packets Se-
quence Numbers
Funkwerk Enterprise Communications GmbH
Description
Enter the IP address to be used as the source address for all
L2TP connections based on this profile.
If this field is left empty, your device uses the IP address of the
interface over which the L2TP tunnel reaches Remote IP Ad-
dress.
Enter the interval (in seconds) between the sending of two L2TP
HELLO messages. These messages are used to keep the tun-
nel open.
The available values are
value
means that no L2TP HELLO messages are sent.
Enter the minimum time (in seconds) that your device waits be-
fore resending a L2TP control packet for which it received no re-
sponse.
The wait time is dynamically extended until it reaches the Max-
imum Time between Retries. The available values are
, the default value is .
Enter the maximum time (in seconds) that your device waits be-
fore resending a L2TP control packet for which it received no re-
sponse.
The available values are
Enter the maximum number of times your device is to try to re-
send the L2TP control packet for which is received no response.
The available values are
Select whether your device is to use sequence numbers for
data packets sent through a tunnel on the basis of this profile.
The function is not currently used.
The function is enabled with
The function is disabled by default.
to
, the default value is
to
, the default value is
to
, the default value is .
.
R1xxx/R3xxx/R4xxx
. The
to
.
Advertisement
Table of Contents
