17 WAN
254
Field
Default Route
Create NAT Policy
Local IP Address
Route Entries
IP Assignment Pool
The menu Advanced Settings consists of the following fields:
Funkwerk Enterprise Communications GmbH
Description
Only if IP Address Mode =
and
Select whether the route to this connection partner is to be
defined as the default route.
The function is enabled with
The function is disabled by default.
Only if IP Address Mode =
and
When you configure an ISDN Internet connection, specify
whether Network Address Translation (NAT) is to be activated.
The function is enabled with
The function is disabled by default.
Only if IP Address Mode =
Assign the IP address from your LAN to the ISDN interface
which is to be used as your device's internal source address.
Only if IP Address Mode =
Define other routing entries for this connection partner.
•
: IP address of the destination host or
network.
: Netmask for Remote IP Address. If no entry is
•
made, your device uses a default netmask.
•
: The lower the value, the higher the priority of the
route (possible values ...
Only if IP Address Mode =
Select IP pools configured in the WAN->Internet + Dialup->IP
Pools menu. If an IP pool has not been configured here yet, the
message
.
.
). The default value is .
appears in this field.
R1xxx/R3xxx/R4xxx