Table of Contents
Advertisement
17 WAN
250
Field
Default Route
Create NAT Policy
Local IP Address
Route Entries
The menu Advanced Settings consists of the following fields:
Fields in the Advanced Settings menu
Field
Block after connection
failure for
Funkwerk Enterprise Communications GmbH
Description
Possible values:
•
(default value): Your device is dynamically
assigned an IP address.
•
: You enter a static IP address.
Select whether the route to this connection partner is to be
defined as the default route.
The function is enabled with
The function is enabled by default.
Specify whether Network Address Translation (NAT) is to be ac-
tivated.
The function is enabled with
The function is enabled by default.
Only for IP Address Mode =
Enter the static IP address you received from your provider.
Only if IP Address Mode =
Define other routing entries for this connection partner.
Add new entries with Add.
•
: IP address of the destination host or
network.
•
: Netmask for Remote IP Address. If no entry is
made, your device uses a default netmask.
•
: The lower the value, the higher the priority of the
route (possible values ...
Description
Enter the wait time in seconds before the device should try
again after an attempt to set up a connection has failed. The de-
.
.
.
). The default value is .
R1xxx/R3xxx/R4xxx
Advertisement
Table of Contents
