Table of Contents
Advertisement
11 Physical Interfaces
144
Field
Connector Type
Line Speed
Funkwerk Enterprise Communications GmbH
Description
or
ically detected. The detected value is displayed, e.g.
.
If you select in the Detection Mode
fields, you must set the interface type field manually.
Possible values:
•
: The port is not used.
•
minating resistor on critical input lines.
•
: V.35 on critical lines, V.28 on uncritical lines.
•
: V.11 on critical lines, V.10 on uncritical lines.
•
: V.28 on all lines.
•
lines.
•
: V.11 on critical lines, V.10 on uncritical lines (9-pole
or 37-pole sub-D plug).
•
: V.11 on critical lines, V.10 on uncritical lines
(25-pole sub-D plug).
•
: V.11 on critical lines, V.10 on uncritical lines incl.
DTR and DSR (25-pole sub-D plug).
Define the connector type of the port used.
When you select in the Detection Mode
or
matically detected. The detected value is displayed, e.g.
If you select in the Detection Mode
fields, you must set the connection type field manually.
Possible values:
•
: The pins are assigned as DTE interface. This setting is
necessary, for example, if the router is connected to a public
data network like Datex-P in Germany.
•
: The pins are assigned as DCE interface.
Only if Connector Type =
used.
fields, the interface type is automat-
or
: V.11 on all lines, 120-ohm ter-
: Unterminated V.11 on all
fields, the connection type is auto-
.
or
Select which speed should be
R1xxx/R3xxx/R4xxx
Advertisement
Table of Contents
