Table of Contents
Advertisement
14 Networking
198
Field
Filter
Direction
High Priority Class
Class ID
Set DSCP/TOS value
(Layer 3)
Funkwerk Enterprise Communications GmbH
Description
Select an IP filter.
If the class plan is new, select the filter to be set at the first point
of the class plan.
If the class plan already exists, select the filter to be attached to
the class plan.
To select a filter, at least one filter must be configured in the
Networking->QoS->QoS Filter menu.
Select the direction of the data packets to be classified.
Possible values:
: Incoming data packets are assigned to the Class
•
ID specified below .
•
(default value): Outgoing data packets are as-
signed to the Class ID specified belowd.
•
: Incoming and outgoing data packets are assigned to
the Class ID specified below.
Enable or disable the high priority class. If the high priority class
is active, the data packets are associated with the class with the
highest priority and priority 0 is set automatically.
The function is enabled with
The function is disabled by default.
Only for High Priority Class not active.
Choose a number which assigns the data packets to a class.
Note: The class ID is a label to assign data packets to specific
classes. (The class ID defines the priority.)
Possible values are whole numbers between
Here you can set or modify the DSCP/TOS value of IP data-
grams according to the specified class (Class ID).
Possible values:
•
(default value): The DSCP/TOS value of the IP da-
.
and
.
R1xxx/R3xxx/R4xxx
Advertisement
Table of Contents
