Table of Contents
Advertisement
3 Installation
10
Connect the SHDSL interface (SHDSL) of your device to the SHDSL connection us-
ing the DSL cable supplied.
(6) Mains connection
Connect the device to a mains socket using the mains adaptor supplied.
Optional connections
• ISDN
Connect the ISDN interface (ISDN or ISDN-x) of the device to your ISDN socket using
the ISDN cable provided.
• Other LANs/WANs
Connect any other terminals in your network to the remaining switch ports (ETH2, ETH3
or ETH4) of your device using other Ethernet cables.
• Serial connection
For alternative configuration options, connect the serial interface of your PC with the seri-
al interface of the device. The serial interface can also be assigned to Ethernet socket 1
(ETH1). Use the serial cable provided, and if necessary connect your network to another
Ethernet socket. However, configuration via the serial interface is not provided by default.
• xDSL modem or DMZ
Connect the WAN interface ( ETH5/DMZ) of your device to an xDSL modem (not sup-
plied) via another Ethernet cable or with the Ethernet connection on your DMZ.
• PRI (only R4100)
Connect the ISDN PRI interface (PRI-0 or PRI-1) of the device to your PRI connection.
• X.21 (only R4300)
Connect an X.21 interface on your device to your X.21/V.35 or X.21/V.36 connection us-
ing a suitable cable (which you can order as an accessory for your router). Make sure
that you use an enabled X.21 interface. The left X.21 interface on the back of the device
is enabled by default ex works. The right X.21 interface can also be enabled if licensed.
• UMTS (only R1200wu)
Insert the UMTS card into the CardBus / UMTS slot.
The device is now prepared for configuration using the Funkwerk Configuration
Interface.
Funkwerk Enterprise Communications GmbH
R1xxx/R3xxx/R4xxx
Advertisement
Table of Contents
