Setting Feeding Method; When Selecting Roll-1 Rear Set (Roll-1 Front Set) By Pressing The [1] Key - GRAPHTEC FC8000 SERIES User Manual

2 -
7

Setting Feeding Method

Feeding method for the loaded media is set.
Loading Roll Media (Rear Loading "REAR SET")
P.2-6
Loading Roll Media (Front Loading "FRONT SET")
P.2-9
Operation
1
If you have already loaded the media, the MEDIA TYPE menu
appears. Select the media type to suit the loaded media.
<Rear loading>
Confirm the media lock is not locked, and press the SELECT.
When Selecting ROLL-1 REAR SET (ROLL-1 FRONT SET) by Pressing
the [1] Key
Select this when you have loaded a roll of media and you wish to start cutting
or plotting from the leading edge. The width and leading edge of the roll media
are detected. The tool carriage moves to the origin point after the initialization
routine has been executed.
Next page
<Front loading>
Media lock
Lower
2-20
CAUTION
Release the media lock before selecting SELECT.
Supplement
Previously used loading information is displayed
l
first in the selection screen of rear loading or
front loading.
It is set to rear loading in the initial setting.
l
The CONTINUE menu parameter appears
l
when the media set lever is raised and then
lowered again after media was previously
loaded, making it possible to select the previous
settings.
When CONTINUE is selected by
pressing the [4] key
The CONTINUE function enables the
continued use of the plotting area, pen position
and origin position that were specified before
the media set lever was lowered. If the current
media is the same size as the last media that
was loaded, the plotter does not detect the
media's edges.