Control Panel - GRAPHTEC FC4200-50 Service Manual

2.2 Control Panel

F1
F2
POWER
PROMPT
Indicator Lamps
The POWER lamp remains lit (green) while the plotter is on.
POWER POWER
The PROMPT lamp lights (red) when the plotter receives data that will cause the pen carriage
PROMPT
to move outside the effective cutting area.
Function Keys
The four function keys F1 through F4 are used to select a menu or to select a function on a displayed menu.
Press the F1 key to select a function during Menu mode, to select Cutter Conditions 1 during
F1
Online status, or to change the cutting FORCE setting after the CONDITIONS key has been
pressed.
Press the F2 key to select a function during Menu mode, to select Cutter Conditions 2 during
F2
Online status, or to change the cutting SPEED setting after the CONDITIONS key has been
pressed.
Press the F3 key to select a function during Menu mode, to select Cutter Conditions 3 during
F3
Online status, or to change the cutter OFFSET setting after the CONDITIONS key has been
pressed.
Press the F4 key to select a function during Menu mode, to select Cutter Conditions 4 during
F4
Online status, or to change the cutting QUALITY setting after the CONDITIONS key has been
pressed.
POSITION Keys
FC4200-UM-251-03-9370
FORCE
SPEED
These POSITION keys function differently according to the plotter ʼs operat-
ing status. They are used to change a setting on a displayed menu during
Menu mode, but are used to move the pen carriage at all other times.
When a key is first initially pressed, the pen carriage moves slowly. When you con-
tinue to hold down the key, the pen carriage starts moving more quickly.
OFFSET
QUALITY
8
NAMES OF THE MAIN PARTS
F3
F4