Operations; Control Panel - GRAPHTEC CE6000 Series Service Manual

3 OPERATIONS

This section explains the function of lamps and keys on the control panel.
3.1

Control Panel

Screen (LCD)
Control Keys
POSITION key ................................There are following functions depending on the operation.
FAST ..............................................The tool carriage or the media will move faster when it is pressed
ORIGIN...........................................It will set the current position as an origin point.
COPY .............................................Copy of data in the buffer memory is output.
Menu Keys
SIMPLE ..........................................You can switch between Simple mode and Normal mode on the
PAUSE/MENU ................................It will switch to the MENU mode. MENU lamp is lit in the MENU mode.
COND/TEST ..................................It will display the screen to set the tool conditions.
CE6000-UM-251-9370
[2] key [1] key [SIMPLE] lamp
[3] key [4] key
Move the tool carriage and media. It will move when it is pressed
once, and continuously move when it is pressed down. It will select
the menu when are displayed in the menu on the screen.
simultaneously with POSITION key. It will work as a menu key when
it is displaying "FAST" on the screen. Press the [FAST] key during
READY status to display the current area and tool carriage position.
On the default screen, pressing the [ENTER] and [ORIGIN] keys at
the same time will allow you to reset the machine. (Only in Normal
mode)
default screen.
Switching modes will reset the machine.
It will go into MENU mode if it is pressed once, and MENU mode will
be turned off when it is pressed again.
Different function are set in the MENU mode.
Data received while in the MENU mode will be stored in the data
buffer.
Use this when checking tool conditions to activate a cutting test.
[SIMPLE] key [MENU] lamp
[FAST] key POSITION (
3-1
3 OPERATIONS
[PAUSE/MENU] key
[ORIGIN] key
[COPY] key
[ENTER] key
) key [COND/TEST] key