8.5
Confirm the Cutting Data
Output of the dump list of the cutting data received by the plotter is possible. It is used to check if the
transmission of cutting data is performed correctly.
Operation
(1) Set a paper larger than A3 size.
(2) Set the pen tool to the tool carriage and select the condition where the pen tool is set.
(3) Press the PAUSE/MENU key at the following menu.
(4) The following menu is displayed, and then press the left arrow key (TEST).
(5) The following menu is displayed, and then press the F3 key (DATA DUMP).
(6) The following menu is displayed, and then confirm that the pen tool is set.
(7) Press the F1 key (DONE).
The error message will be displayed when the command setting is set to "AUTO".
Set the command setting that is corresponding to the application software.
(8) The following menu is displayed, and then send the data to plotter from the PC.
(9) Turn the power off to stop the printing.
CE6000-UM-251-9370
8-6
8
SERVICE MODES