Saving Configuration Entered With The Gui; Combining Gui And Cli Configuration; Configuring Multiple Devices - Allied Telesis AR410 User Manual

40
Save button
To freeze the banner's display so that the help does not change when you
move the mouse, press the [Ctrl] key. To unfreeze, press [Ctrl] again. Note
that element information is not available for most entries in tables. To see
descriptions of the columns of tables, click Complete Help Page.
■
Click Complete Help Page to see all available information, including the
element information, in a separate printable window.

Saving Configuration Entered with the GUI

Configuration changes applied using the GUI can be saved to a configuration
script by clicking the Save button at the top of the sidebar menu. A pop-up
Save window gives you the option of saving to the current configuration file,
another existing file, or a new file. You can also choose to use this configuration
at bootup.
When the Save button is red, this indicates that changes have been made to the
configuration and not yet saved. If you attempt to exit the GUI without saving
the configuration, a pop-up window will allow you to choose whether or not to
save.

Combining GUI and CLI Configuration

On some models the GUI makes it easier to configure several features by using
scenario-based wizards. For these features, the GUI requires some
configuration parameters to use particular values (for example, firewall policy
names). These features should be configured either with the GUI or the CLI,
but not both. In particular, you cannot configure these features using the CLI
and modify them using the GUI. These features are:
■
VPN client
■
Firewall
For other features and protocols, you can alternate between the GUI and the
CLI without difficulty. Note that GUI pages will not automatically refresh to
reflect changes in the CLI configuration; you must reload the relevant page (for
example, by clicking the Refresh button on your browser).

Configuring Multiple Devices

If you are configuring a number of routers with similar requirements, you may
wish to:
1. Configure one device, using either the CLI or the GUI
2. Save that configuration. This creates a configuration file, stored in the
router's FLASH memory. The file consists of a sorted list of the CLI
commands that make up the configuration
3. Upload that file to a PC, using either the CLI or the GUI
4. Open the file in a text editor, make changes as required, and download the
file onto each router you need to configure.
AR400 Series Router User Guide
Software Release 2.7.1
C613-02021-00 REV F