Table of Contents
Advertisement
English
4.
Turn the ribbon knob two or three times in the direction of the arrow to
take up any slack in the ribbon.
5.
Insert the ribbon cassette in the printer until it clicks and rotate the
cassette's knob two or three times. This is necessary to place the ribbon in
the correct position. Make sure that the ribbon is installed below the
printer head without wrinkles or creases.
If the ribbon is not installed correctly, remove the cassette and repeat steps
4 & 5 above.
Using the Power Switch Cover
WARNING:
If an accident occurs when the power switch cover is attached, unplug
the DC cable immediately. Continued usage may lead to fire.
You can use the power switch cover to make sure that the power switch is not
accidentally pressed. If you want to use this cover, install it as shown in the
illustration below.
Installing the Stamp Unit
Referring to the illustration below, insert the stamp unit into the correct
position in the printer.
CAUTION:
Please check the stamp print from time to time to prevent the stamp
print from becoming too light.
6 RP-U420 User's Manual
Advertisement
Table of Contents
