Fuelpressure Checking - Triumph DAYTONA 675 Service Manual

3. Ensure the locating peg on the fuel pump assembly
is located in the cut out on the mounting plate and
the offset hole is positioned as shown below.
1. Offset hole position
2. Locating peg
4. In the sequence shown below, tighten the mounting
plate fixings to 9 Nm.
o/
Fuel pump mounting plate torque sequence
Refit the fuel tank (see page 10-90).
S.
6. Reconnect the battery, positive (red) lead first.
7. Refit the rider's seat (see page 16- 17).
L..
I UMP
Service Manual - Daytona 675, Street Triple and Street Triple R
Fuel System/Engine Management
Fuel Pressure Checking
A Warning
Observe the fuel handling precautions given in the
general information section.
Fuel pressure is checked using service tool 13880001.
_ _
R l^^
u
cdgh
Tool T3880001
1. Remove the rider's seat (see page 16-17).
2. Remove the fuel tank (see page 10-89) and place on
a suitable support, close to the motorcycle.
3. Using the extension cable 13880123, carefully
connect the fuel pump connection on the main
harness to the fuel tank. Connect the other end of
the extension cable to the motorcycle main harness.
4. Select the fuel pressure gauge adapter marked 'B'
from service tool T3880001.
A Warning
Always us the correct fuel pressure gauge adapter
(adapter 'B' for Daytona 675, Street Triple and
Street Triple R). Use of an incorrect adapter will result
in a fuel leak. A fuel leak can result in a fire causing
damage to property and injury t o pe rsons.
9
^
1 0.93