Inspection - Triumph DAYTONA 675 Service Manual

8. At the throttle grip end, slide off the rubber boot and
release the screws which secure the two halves of the
throttle grip guide to each other.
1. Throttle grip guide
2. Screws
3. Rubber boot
9. Separate the two halves of the guide then release the
inner cables from the throttle grip.
1. Opening cable
2. Closing cable
10. Detach the cables from the motorcycle.

Inspection

1. Check that both the throttle cables operate smoothly,
without sticking or binding. Replace the cables if
there is any doubt as to their correct operation.
Installation
1. Locate the cables to the frame following the routing
noted during removal.
Service Manual - Daytona 675, Street Triple and Street Triple R
I UMP
Fuel System/ Engine Management
2. Engage the inner cable nipples to the throttle grip,
ensuring the 'opening' cable is located in the upper
slot in the throttle grip, and the 'closing' cable is
located to the lower slot.
I
1. Opening cable
2. Closing cable
3.
Assemble the two halves of the cable guide ensuring
that the outer cables are correctly located in the
guide and the guide is positioned on the handlebars
as noted prior to removal. Fit and tighten the two
screws to 4 Nm.
1. Throttle grip guide
2. Screws
3. Rubber boot
4. Refit the boot.
5. Attach the other end of the inner cables to the
throttle cam ensuring the 'opening' cable is fitted to
the top of the cam and the 'closing' cable to the
bottom.
14
1 0.105