Triumph DAYTONA 675 Service Manual page 78

Cylinder Head
Remove the throttle bodies, injectors and fuel rail
8.
from the cylinder head (see page 10-106).
Note:
• It is not necessary to disconnect the throttle
cables. Instead, lay the assembly over the
frame during the period when the engine is
separated from the frame.
9. Progressively release the camshaft cover bolts in the
sequence shown below.
Note:
• Two shorter bolts are fitted at the end
adjacent to the camshaft drive chain.
1 5
2
6
cdra
Camshaft Cover Bolt Release Sequence
10. Remove the camshaft cover from the motorcycle.
ACaution
Never use a lever to remove the camshaft cover from
the head.
Using a lever will cause damage to the head and
camshaft cover which could lead to an oil leak.
Remove the camshaft cover gasket. If necessary,
11.
recover the three dowels from the secondary air
injection holes in the camshaft ladder (these may
come away in the camshaft cover or gasket).
12. Discard the camshaft cover gasket and bolt seals.
13. Remove any residual oil from the front of the head
using a syringe or lint free cloth.
3.8 Service Manual - Daytona 675, Street Triple and Street Triple R
Installation
1.
Refit the three dowels to the camshaft ladder.
3
1. Dowels
2. Fit a new camshaft cover seal to the cylinder head.
Ensure the groove in the gasket is correctly seated to
the head. Ensure the plug tower seals and the dowels
are correctly located.
i
4
, Q,
1. Camshaft cover seal
2. Dowels
3. Plug tower seals
3.
Fit the camshaft cover, ensuring that the gasket
remains in the correct position.
4. Lubricate the new camshaft cover screw seals with
clean engine oil. Fit the camshaft cover screws and
screw seals and tighten until finger tight.
5. Finally, tighten the camshaft cover screws, in the
same order as for removal, to 10 Nm.
6. Refit the throttle bodies, injectors and fuel rail to the
cylinder head (see page 10- 108).
7. Check the throttle cable adjustment (see page 10-
103).
n
3
1l,I MP