Throttleposition Sensor; Removal - Triumph DAYTONA 675 Service Manual

Fuel System/Engine Management
Note:
• The balance throttle screen will show the
vacuum value of each throttle in mm/hg. In
addition, when the throttles are balanced to
an acceptable range of each other the word
'THROTTLES BALANCED in green text will
appear on the right of the screen. At this
point, no further adjustment is necessary or
productive.
• If the throttles are not balanced to each
other the word 'THROTTLES UN-
BALENCED' in red text will appear on the
right of the screen. At this point adjustment
will be necessary.
• The adjusters operate on the outer cylinders
only (cylinders 1 and 3). The centre throttle
(cylinder 2) adjustment is fixed, this being
controlled by the idle speed control stepper
motor. Note that the centre reading will
alter slightly as the two outer cylinders are
adjusted.
• DO NOT attempt to adjust the centre
throttle stop screw, located below the idle
stepper motor. The stop screw is set at the
factory during manufacture, and must not
be adjusted.
14. Using the throttle adjusters, make adjustments to the
two outer cylinders until the word 'THROTTLES
BALANCED' in green text appears.
1. Adjusters
15. When balanced, stop the engine and disconnect the
diagnostic tool.
16. Disconnect the fuel pressure gauge adapter and
wiring extension.
17. Refit the airbox (see page 10-96).
18. Refit the fuel tank (see page 10-90).
19. Remove the exhaust extraction hoses from the
silencer.
20. Refit the rider's seat (see page 16-17).
1 0.110
Service Manual - Daytona 675, Street Triple and Street Triple R
Throttle Position Sensor

Removal

1.
Remove the rider's seat (see page 16- 17).
2. Disconnect the battery, negative (black) lead first.
3. Remove the fuel tank (see page 10-89).
4.
Remove the airbox (see page 10-95).
5.
Remove the throttle body assembly (see page 10-
106).
6. Release the two screws and rotate the throttle
position sensor clockwise through 45
from the left hand end of the throttle body. Collect
the O-ring on disassembly.
1. Throttle position sensor
2. Screws
3. 0-ring
Installation
1. Fit the replacement throttle position sensor ensuring
the O-ring is positioned correctly between the sensor
and throttle body. Rotate the sensor through 45°
anti-clockwise until the screw holes align.
2.
Engage the new screws and washers supplied and
part tighten such that the sensor can still be rotated.
3. Position the throttle body assembly near to its fitted
position and reconnect the sensor and all other
throttle body electrical connectors.
4. Reconnect the battery, positive (red) lead first.
5. Attach the Triumph diagnostic tool to the dedicated
plug, refer to the Triumph Diagnostic Tool User
Guide.
6. Turn the ignition to the 'ON' position.
7. On the diagnostic software navigate to and select the
'ADJUST TUNE' option.
0
to remove it
Ii1MP