Triumph DAYTONA 675 Service Manual page 330

a.i
Remove the coolant pressure cap on the radiator
8.
9. Position a container to collect the displaced coolant.
10. Slacken the clip then release the bottom hose from
the radiator and allow the coolant to drain.
1. Bottom hose
11. Remove the drain bolt from the coolant outlet tube,
located next to the heat exchanger and allow the
coolant to drain. Discard the sealing washer.
1. Coolant outlet tube
2. Drain bolt
L UMP
Radiator Cap
Service Manual - Daytona 675, Street Triple and Street Triple R
Filling
1. Incorporating a new sealing washer, refit the drain
bolt to the coolant outlet tube and tighten to 10 Nm.
2. Reconnect the bottom hose and tighten the hose
clip.
3. Remove the bleed screw from the right hand side of
the radiator.
1. Bleed screw
4. Remove the bleed screw from the top hose.
1. Top hose
2. Bleed screw
S. Slowly add coolant mixture to the system, through
the filler opening in the radiator, until the system is
full. If the system has filled correctly and fully, there
should be coolant visible through the bleed screw
opening as well as in the filler opening.
6. If there is no coolant visible through the bleed screw
opening, but the filler side appears to be full, attach a
length of clear tubing to the bleed screw spigot and
syphon coolant into the bleed screw side of the
radiator.
Note:
• A hand operated vacuum pump or similar
should be used to syphon the coolant
through the system.
Cooling
11.9