Electrical
Headlight Assembly - Daytona 675
Removal
Remove the rider's seat (see page
1.
Disconnect the battery, negative (black) lead first.
2.
Remove the cockpit (see page
3.
Release the four fixings securing the headlight to the
4.
cockpit. Remove the headlight.
c
1. Headlight
2. Fixings
Installation
1.
Installation is the reverse of removal, noting the
following:
Note:
•
Tighten the headlight fixings to 3 Nm.
•
Reconnect the battery, positive (red) lead
first.
1 7.24
Service Manual - Daytona 675, Street Triple and Street Triple R
Headlights - Street Triple and
Street Triple R
Headlight Adjustment
16-17).
Note:
16-23).
1. Vertical adjuster fixings
1.
2.
3.
4.
5.
6.
7.
8.
1. Horizontal beam adjusters
•
The vertical beams of the left hand and right
hand headlights can only be adjusted
together. Independent adjustment is not
possible.
Switch the headlight dipped beam on.
Remove the adjuster cover.
Slacken the clamp bolt sufficient to allow restricted
movement of the headlights.
Adjust the position of the headlights to give the
required beam setting.
Tighten the clamp bolt to 30 Nm.
Re-check the headlight beam settings.
Switch the headlights off when both beam settings
are satisfactorily set.
Refit the adjuster cover.
ILIMP