Triumph DAYTONA 675 Service Manual page 371

Front Suspension
9. Retain the bush, washer and seal with the new circlip
1. Dust seal
2. Circlip
3. Tool T3880002
10. Position the dust seal to the outer tube.
11. Invert tool T3880003 and, using hand pressure only,
push the dust seal squarely into the outer tube.
12. Fill the fork with oil (see page 13-8).
13. Position the fork assembly as for compression of the
fork spring during strip down.
14. Daytona 675 and Street Triple R only: Rethread
the damper rod locknut leaving 13 mm of thread
exposed above the nut.
13.14
Service Manual - Daytona 675, Street Triple and Street Triple R
15. Street Triple only: Screw the damper rod locknut
to the bottom of the damper rod threads.
16. Refit the fork spring, close wound end uppermost,
spring spacer and washer.
1. Washer
2. Spring spacer
3. Spring
4. Damper rod
17. Attach tool 3880085-T0301 to the threads of the
damper rod and pull the damper upwards.
u.
Warning
While re-compressing the fork spring and while the
spring holder is in place always wear protective
equipment for the face and eyes and never stand
directly above or look directly down on the fork. If the
spring compressor or holder should dislodge or detach,
the resulting release of spring tension could cause parts
to fly off resulting in iniury to the user.
18. Refit tool T3880067 as previously described,
compress the fork spring and refit the spring holder.
1
1. Damper locknut
2. Tool T3880067
3. Spring holder (part of T3880067)
-
I uMP