Lowoil Pressure Warning Light Switch; Installation; Sump - Triumph DAYTONA 675 Service Manual

Low Oil Pressure Warning Light
Switch
The low oil pressure warning light switch is located in the
upper crankcase, behind the cylinder head.
1. Low oil pressure warning light switch
2. Electrical connection
1. Remove the rider's seat (see page 16-17).
2. Disconnect the battery, negative (black) lead first.
3. Disconnect the electrical connection to the switch.
4. Remove the switch and collect the copper washer.
I nstallation
1. Incorporating a new copper washer, fit the switch
and tighten to
13 Nm.
2. Refit the electrical connection.
3. Reconnect the battery, positive (red) lead first.
4.
Refit the rider's seat (see page 16-17).
Service Manual - Daytona 675, Street Triple and Street Triple R
I UMP

Sump

Removal
1. Remove the rider's seat (see page 16- 17).
2. Disconnect the battery, negative (black) lead first.
3. Drain the engine oil (see page 8-7).
Warning
A .
The oil may be hot to the touch. Contact with hot oil
may cause the skin to be scalded or burned.
Warning
Prolonged or repeated contact with engine oil can lead
to skin dryness, irritation and dermatitis. In addition used
engine oil contains potentially harmful contaminants
which can cause cancer. Wear suitable clothing and
avoid skin contact.
4.
Remove the exhaust system (see page 10-116 for
Daytona 675 or page 10-122 for Street Triple and
Street Triple R).
©
Warning
The exhaust system will be hot if the engine has recently
been running. Always allow sufficient time for the
exhaust to cool before working on or near the exhaust
system.
Contact with a hot exhaust could result in burn injuries.
5. Release the bolts securing the sump to the lower
crankcase.
1. Sump
2. Fixings
Lubrication
8.15