Front Wheel - Triumph DAYTONA 675 Service Manual

Wheels/Tyres
4
Warning
Accurate wheel balance is necessary for safe, stable
handling of the motorcycle. Do not remove or change
any wheel balance weights. Incorrect wheel balance may
cause instability leading to loss of control and an
accident.
When wheel balancing is required, such as after tyre
replacement, see your authorised Triumph dealer.
Only use self-adhesive weights. Clip on weights will
damage the wheel and tyre resulting in tyre deflation,
loss of control and an accident.
A
Warning
When replacement tyres are required, consult your
authorised Triumph dealer who will arrange for the tyres
to be fitted according to the tyre manufacturers
instructions.
When tyres are replaced, allow time for the tyre to seat
itself to the rim (approximately 24 hours). During this
seating period, ride cautiously as an incorrectly seated
tyre could cause loss of control or an accident. Initially,
the new tyre will not produce the same handling
characteristics as the worn tyre and the rider must allow
adequate riding distance (approximately 100 miles) to
become accustomed to the new handling characteristics.
After both 24 hours and 100 miles, the tyre pressures
should be checked and adjusted and the tyre examined
for correct seating and rectified as necessary.
Use of a motorcycle when not accustomed to its
handling characteristics may lead to loss of control and
an acci dent.
1 5.6
Service Manual - Daytona 675, Street Triple and Street Triple R

Front Wheel

Removal
A
Warning
Before starting work, ensure the motorcycle is stabilised
and adequately supported. This will help prevent it from
falling and causing injury to the operator or damage to
the motorcycle.
1. Position the motorcycle on a paddock stand.
2. Detach and the support the front brake calipers;
• see page 14-21 for Daytona 675 up to
VIN 381274 and Street Tiple R;
• see page 14-17 for Daytona 675 from
VIN 381275;
• see page 14-26 for Street Triple.
Note:
• It is not necessary to disconnect the brake
hoses.
A
Warning
Do not allow the calipers to hang on the brake hoses as
this may damage the hoses.
Damaged hoses could cause brake failure leading to loss
of control and an a cci de n t.
3. Raise and support the front of the motorcycle.
4. Slacken both pinch bolts at the lower end of the left
hand fork.
Nil
1
I W\
x
1. Fork pinch bolts
5. Release and remove the wheel spindle, which is
threaded into the right hand fork.
Il1MP