Triumph DAYTONA 675 Service Manual page 407

Installation
1. Position the caliper over the disc and tighten the
caliper bolts to 35 Nm.
1. Caliper bolts
2. Fit the brake pads (see page 14-16).
3. Connect the brake hose(s) to the caliper
incorporating new sealing washers on each side of all
hose connections.
4. Tighten the banjo bolt to 25 Nm.
Warning
Use only DOT 4 specification brake fluid as listed in the
general information section of this manual. The use of
brake fluids other than those DOT 4 fluids listed in the
general information section may reduce the efficiency of
the braking system leading to loss of motorcycle control
and an accident.
Observe the brake fluid handling warnings given earlier
in this section of the manual.
5. Fill the master cylinder with new, DOT 4 brake fluid
from a sealed container.
Bleed the front brake line (see page 14-13).
6.
7 Check for correct brake operation.
A
Warning
It is dangerous to operate the motorcycle with defective
brakes; you must have your authorised Triumph dealer
take remedial action before you ride the motorcycle
again. Failure to take remedial action may result in
reduced braking efficiency leading to loss of motorcycle
control and an accident.
Service Manual - Daytona 675, Street Triple and Street Triple R
lump
Front Brake Caliper - Daytona 675
from VIN 381275
Removal
Ak
Warning
Before starting work, ensure the motorcycle is stabilised
and adequately supported. This will help prevent it from
falling and causing injury to the operator or damage to
the motorcycle
ACaution
To prevent paint damage, do not spill brake fluid onto
any area of the bodywork. Spilled brake fluid will
damage paintwork.
1.
Disconnect the brake hose at the caliper (two hoses
on right hand caliper), and place the free end of the
hose(s) in a suitable container to collect the brake
fl uid.
2. Remove the brake pads (see page 14-17)
Brakes
1 4.23