Installation - Triumph DAYTONA 675 Service Manual

From engine number 330119 only: Release the
6.
three fixings securing and remove the retaining
plate.
O
1. Fixings
2. Retaining plate
3. Bearing housing
7. All engines: Insert two M6 bolts into the two
threaded holes at the periphery of the bearing
housing. Evenly and progressively tighten both bolts
to draw the bearing housing and input shaft from
the crankcase.
0
cdmt
1. Bearing housing
2. M6 threaded holes
3. Transmission oil tube
8. If required, the transmission oil tube can now be
removed. Remove and discard the three oil tube
O-rings.

Installation

1. If removed, check the transmission oil tube for
blockages and contamination. Carefully fit new
O-rings to the transmission oil tube and insert the
tube into the crankcase, ensuring the tag on the tube
locates in the slot in the crankcase.
Service Manual - Daytona 675, Street Triple and Street Triple R
IIiMP
2.
3.
3
4.
0
I!
1. Bearing housing
2. Fixings
3. M6 threaded holes
4. Transmission oil tube
5.
6.
0
1. Fixings
2. Retaining plate
3. Bearing housing
7.
Transmission
Locate the input shaft to the upper crankcase,
installing it through the aperture for the bearing
housing.
Fit the bearing housing into the aperture, by hand, as
deeply as possible.
Using the old fixings, evenly and progressively
tighten them to draw the bearing housing into the
upper crankcase until fully home. Remove and
discard the fixings.
Up to engine number 330118: Install new fixings
to the bearing housing and tighten to 12 Nm.
From engine number 330119: Fit the retaining
plate. Install new fixings and tighten to 12 Nm.
3
Refit the selectors and shafts (see page 7-9).
7.13