Adjustment - Street Triple And Street Triple R - Triumph DAYTONA 675 Service Manual

• Hold the adjuster nut in position while
tightening the locknut to 40 Nm.
2
1
CO W /
1. Adjuster nut
2. Locknut
3. Tool 13880023
8. Refit the top yoke to the forks.
9. Tighten the top nut to 90 Nm.
10. Install the handlebar to top yoke fixings and tighten
to 5 Nm.
11. Tighten the top yoke clamp bolts to 26 Nm.
12. Fit the bracket for the front brake fluid reservoir and
ti ghten the fixing to 15 Nm.
13. Recheck the bearing adjustment (see page
Service Manual -
IUMp

Adjustment - Street Triple and Street Triple R

1.
Raise and support the front of the motorcycle.
2.
Release the fixings securing the handlebar clamps to
the risers, detach the clamps and release the
handlebar.
3.
As an assembly, raise the handle bars until clear of
the top yoke. Rest the assembly forward of the
steering stem such that access to the headstock top
nut and the adjustment nuts is unrestricted. Ensure
the master cylinder remains in an upright position.
4.
Slacken the top yoke clamp bolts.
If the lower yoke fixings are also slackened, the forks will
no longer support the weight of the motorcycle.
Do not slacken the lower yoke fixings as, in this
condition, the motorcycle could topple over causing
damage and/or risk of injury.
Care must be taken when removing the headstock top
nut, to ensure that the top nut and top yoke do not
become scratched. Protect the surfaces with a suitable
cloth or tape to prevent scratching.
13-15).
5. Slacken the headstock top nut.
1. Headstock top nut
6. Ease the top yoke from the forks and support while
detached.
7.
Adjust the bearing free-play as follows, all using tool
T3880023:
•
•
Daytona 675,
Street Triple
Front Suspension
AWarning
ACaution
Remove the locknut and tab washer.
Slacken the adjuster nut then tighten to
40 Nm.
and Street
Triple R
13.17