Coolant Replacement - Street Triple And Street Triple R; Drainage - Triumph DAYTONA 675 Service Manual

Cooling
20. With the aid of an assistant, lean the motorcycle fully
over to the right hand side, and then the left hand
side, to release air trapped in the cooling system.
21. Start the motorcycle. Briefly raise the engine speed
several times to allow any air to be expelled from the
system.
22. Allow the engine to run until the cooling fan
operates.
23. Stop the motorcycle and allow the engine to cool.
AWa
Do not remove the coolant pressure cap when the
engine is hot. When the engine is hot, the coolant inside
the cooling system is hot and also under pressure.
Contact with the pressurised coolant will cause scalds
and skin damage.
24. Check and top up the coolant level as necessary.
25. Check the expansion tank level and top up if
necessary.
26. Refit the rider's seat (see page 16-17).
Refit the lower fairings (see page 16-22).
27.
11.8
Service Manual - Daytona 675, Street Triple and Street Triple R
r n -`^*i n g
Coolant Replacement - Street Triple
and Street Triple R

Drainage

Note:
• Prior to disassembly of the coolant hoses,
note the orientation and position of the hose
clips to help ensure that they are returned
to the same positions and orientation on
assembly.
1. Position the motorcycle on level ground on the
sidestand.
2. Remove the rider's seat (see page 16-17).
3. Disconnect the battery, negative (black) lead first.
Warning
• Ak
Do not remove the coolant pressure cap when the
engine is hot. When the engine is hot, the coolant inside
the radiator is hot and also under pressure. Contact with
the pressurised coolant will cause scalds and skin
damage.
4. Release the fixing securing the right hand direction
indicator to the radiator cowl.
5. Release the three fixings securing the radiator cowl
to the radiator.
1. Radiator cowl
2. Direction indicator fixing
3. Fi
xings
6. Without disconnecting the direction indicator
connections, tie the radiator cowl aside. Do not allow
the radiator cowl to hang from the direction indicator
harness.
7. Repeat steps 4 to 6 above for the left hand radiator
cowl.
Il1MP