Alternatorrectifier; Daytona 675 Up To Vin 381274, Street Triple And Street Triple R All Vins; Daytona675 From Vin 381275 - Triumph DAYTONA 675 Service Manual

4. Tighten the rotor retaining bolt to 120 Nm
1. Rotor
2. Tool T3880375
3. Centre bolt
5. Remove tool 13880375.
6. Locate the stator and crankshaft position sensor to
the engine cover.
7. Apply silicone sealer to the cable grommet (at the
factory, ThreeBond 1215 is used) and align the cable
to the exit slot.
8. Fit the cable retainer bracket and tighten a new
retainer bolt to 6 Nm.
9. Tighten the new stator bolts to 12 Nm.
10. Tighten the new crankshaft position sensor bolts to
6 Nm.
11. Position a new gasket to the crankcase dowels then
refit the left hand engine cover.
12. Ensure the bolt with the copper washer is correctly
located. Refit the solenoid/fairing bracket to the front
two bolts. Tighten the cover bolts to 9 Nm.
1. Left hand engine cover
2. Copper washer position
3. Solenoid bracket
13. Daytona 675 only: Refit the left hand lower fairing
(see page 76-22).
Service Manual - Daytona 675, Street Triple and Street Triple R
I UMP
14. Reconnect the battery, positive (red) lead first.
15.
Refit the seat (see page 16-17).
Alternator Rectifier
The rectifier does not contain any serviceable parts and
must be replaced if faulty.
Daytona 675 up to VIN 381274, Street Triple
and Street Triple R all VINs
The alternator rectifier is located in between the rear
suspension unit and the gearbox. To access the rectifier
connector, remove the fuel tank (see page 10-89).
Daytona 675 from VIN 381275
The alternator rectifier is located under the cockpit's right
hand infill panel. To access the rectifier, remove the right
hand lower fairing (see page 16-20).
Electrical
1 7.35